SICK PAC50 Betriebsanleitung Seite 73

Operating Instructions
The factory setting is:
p1= 0.6 bar
= 0.4 bar
= 30 seconds
out
PVOL = 0.0 liters
Alternatively, the measurement
the sensor as an input signal via QI.
4.3.3 Changing the parameters
Pressing the V pushbutton for longer (> 2 seconds) takes you to the LTPI setting. To change this,
be pressed. The value can be changed using A or V. To apply the desired value,
Pressing_!he pushbutton takes you to the LTP2 setting, which follows the same procedure as LTPI.
can then be pressed to define the value for the measurement
to 9,999) using A or V and apply it using
In the next menu step, which is again accessed using V, the volume of the system or section to be measured
can be set (if known to the user) by first pressing -e and then the A or
entered, the user is shown information
ment.
In the next step, the menu item SET AMODE is accessed
and then A or V, you can select whether the analog output is to be used to transmit the value for dT or dP.
As the last step, pressing V takes you to the menu item STOPLT.Using -e for confirmation and A or
selection, the user can decide here whether
pressure switch (selection
By pressing the pushbutton
mode.
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Product description
can be started via a pulse from a control.
in LT mode
on the leakage rate in L/min on the display at the end of the measure-
they want to use the sensor in LT mode
"YES"). The corresponding
again, the sensor is then switched
Here, the pulse is transmitted
duration
pushbutton. If the volume is
by pressing the pushbutton
selection is confirmed using
to measurement
Operating
PAC50
to
must
must be pressed again.
TOUT (in seconds from 0.1
again. By pressing
for
selection "NO") or as a
standby in the relevant
Instructions I SICK 73