SICK PAC50 Betriebsanleitung Seite 82

Operating Instructions
+3
40 0
Figure 11: Opening in the switch panel
5.3 Installation with a wall mounting
Secure the fixing element in the mounting rail support for the pressure switch, see Figure 10.
Figure 12: Installation with a wall mounting
82 Operating Instructions
Installation/Mechanical
Insert the switch panel mounting frame into the switch panel from the outside,
making sure that the openings
From above, push the fixing rails into the switch panel mounting
as possible [2].
Carefully screw in the four pre-fitted, short fixing screws for the fixing rails as
far as possible (max. 8 Ncm) [3].
Insert the pressure switch into the switch panel mounting
behind [4]
Secure the fixing element in the mounting rail support for the pressure
switch [5].
Carefully screw the fixing element
long fixing screws (max. 8 Ncm) [6].
Carefully retighten all the screws (max. 8 Ncm).
set
set
I SICK
connection
for the fixing rails are facing upward [1]
and the fixing rails together
8017612/1DZP
Subject to change without notice
PAC50
frame as far
frame support from
using the two
/ 2022-06-23 | PAC50