SICK PAC50 Betriebsanleitung Seite 77

Operating Instructions
Measuring mode Display of the
applied pressure
Programming
Value of the selected
mode
parameter
Table 3: Indicators in display areas for LT mode
Once the set switching points (SPI/2,
tive switching point display areas changes
The color change can be set using the "DISC" function:
Red if the switching point is not reached or undershot,
window, and green if the switching
("DISC" function: OD)
Red if the switching point is exceeded or if the applied pressure is outside the defined window, and green
if the switching point is not reached or undershot,
function: DU)
Always red (no color change, "DISC" function: RED)
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Product description
Set pressure unit CI: Status
leakage measure-
ment (Wait User,
MEAS DONE) or
TimA until
reached, error
message ("WARN")
if the supply pres-
sure is not sufficient,
"DONE" once
measurement
been completed
(without errors)
C2: QL, dT, dP
alternately
or P>PI until
reached or P<P2
until P2 is reached
Selected parameter
RPI/ 2, FHI/2, or FL1/2) have been reached, the color of the respec-
between green and red.
or if the applied
point is exceeded or if the applied
or if the applied
of the
measurement
activation" status
P1 is
the
has
P1 is
pressure is within the defined
pressure is outside the window
pressure is within the window ("DISC"
Operating Instructions
PAC50
EI: Timer in seconds
until P1 is reached
E2: Measured
values for QL, dT, dP
I SICK
77