SICK PAC50 Betriebsanleitung Seite 72

Operating Instructions
P = pressure
Psupply=PO
1
2
to tl
Timer A
= = Storedparameters
Figure 6: Leakage measurement schematic
4.3.2 Starting the leakage measurement
After connecting the sensor to a voltage source that meets the specifications,
shows the initialization "SICK PAC50-LT" and the corresponding
It then immediately switches
applied poas well as "Wait" and "User" in the bottom two lines. Everything is displayed in green here.
By pressing the pushbutton
preset parameters.
72 Operating Instructions
Product description
Pee
= adjustable parameters
diagram
to Leakage Tester mode. The display indicates
in the middle for slightly longer (> 200 ms), the measurement
SICK
V=volume
end
t [secl
out
= output value
the sensor starts and initially
firmware version "FWv x.xx" on the display.
the system pressure
8017612/1DZP
Subject to change without notice
PAC50
currently
starts with the
/ 2022-06-23 | PAC50