Product Description - Sick Pac50 Betriebsanleitung

Operating Instructions
4 Product description
The PAC50 establishes the applied
and (as an option) an analog output signal. The applied
parameter settings are made using three large pushbuttons.
4.1 Switching functions
4.1.1 Hysteresis function
In the event of rising system pressure,
(SP). If the pressure drops again, the output does not switch back until the reset point (RP) has been reached.
If the applied pressure fluctuates
the switching state of the outputs
p
1
Normally open
1
Normally closed
Figure 2: Hysteresis function in the event of excess pressure
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice

Product description

compressed air pressure
(excess pressure in all available
the output switches
around the switching
stable (see Figure 2).
and converts this to a digital switching
pressure value is shown on an LCD display. The
measuring ranges)
upon reaching the appropriate
point set on the pressure switch, the hysteresis
Operating
PAC50
signal
switching point
keeps
Instructions I SICK 67