Process Connection - Sick Pac50 Betriebsanleitung

Operating Instructions

5.6 Process connection

via 1/4 NPT female
All variants with type code PAC50-xNx feature
the underside of the device. This means that the alternative
on the back cannot be used.
The G 1/4" blind plug from the rear process connection
thread. That means it must not be used to close the 1/4" NPT process connection
of the housing. This can lead to the destruction
connection on the underside
E
Figure 15: 1/4" NPT female thread
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Installation/Mechanical
thread (Figure 15)
a process connection
is not compatible
of the sensor. The screw-in depth for the 1/4" NPT process
is max. 9 mm.
connection
with a conical 1/4" NPT female thread on
process connection with a G 1/4" parallel thread
with the conical 1/4" NPT female
located on the underside
Operating Instructions
PAC50
I SICK 85