Commissioning; Before Commissioning The Device; System Operation Settings Ui 800 - Bosch Src 100 Rf Installations- Und Bedienungsanleitung

Commissioning

Component
App Bosch
HomeCom Easy
Repeater
Table 1
4 Commissioning
4.1

Before commissioning the device

▶ Professional installation of all required components by a specialist.
During installation and commissioning, the installation instructions,
operating instructions and, for example, warning notices for the
individual components must be observed. This and other information
can be found in the relevant documentation for the respective
components.
▶ Search for Bosch EasyService in the relevant app store, select and
install on the smartphone.
The required pairing functionality can be found in the part of the Bosch
EasyService app free of charge; a licence is not required.
▶ Plug the K 30 RF/K 40 RF into the heat generator.
It is not possible to activate (set) the individual control feature if the
K 30 RF/K 40 RF is not plugged in. The required menus are only
displayed if a corresponding K 30 RF/K 40 RF is connected to the
system.
56
Specification Comment
with K 30 RF from • Available free of charge in the app store
software version
• Internet connection of the K 30 RF/K 40 RF required
V2.0.0
with K 40 RF from
software version
It may be necessary to update the software of the app and also the K 30 RF/
V3.2.0
K 40 RF to a higher software version than specified in this document (
operating instructions of the K 30 RF/K 40 RF). Floor-standing condensing
boilers, for example, are only compatible from software version V03.00.00.
from software version Repeater REP
V2.8.14
• Type F plug type
• to improve the wireless range
• expected to be available in Luxembourg, the Netherlands, Italy and Hungary
from 06/2025
Repeater not available in Switzerland, Belgium, the Czech Republic and Poland.
4.2 Commissioning
Only the settings relevant to the individual control feature are described
below with regard to commissioning
4.2.1

System operation settings UI 800

▶ Carry out system operation UI 800 on the system control unit as
usual.
▶ Select the desired heating circuit Remote control type > Single
Room Control.
Fig. 3 Example of wall hung gas condensing boiler; individual control
radiator
After selecting individual control as remote control, a new menu entry
appears in the relevant heating circuit menu Configure Single Room
Control. Important settings relevant to individual control are
summarised here.
▶ Select the desired control type in the relevant heating circuit under
Control type (also found in the menu Configure Single Room
Control):
– Single room-dependent
– Outside temp. with base point
– Outside temp.-compensated
0010047129-001
SRC 100 RF – 6721856014 (2024/11)