instagrid LINK MAX Benutzerhandbuch Seite 31

6. Regular maintenance
• Draw up a cleaning schedule for the device, in particular in environments such as construction sites,
where dust and dirt are quick to accumulate
• Always pay attention to signs of wear such as cracks in the housing or damaged gaskets as these can
impair the safety and performance of the device
Avoid:
• cleaning the Instagrid LINK MAX with a hose or a high-pressure cleaner, even in case of heavy dust or
concrete deposits The direct impact of water could impair the IP type of protection of the device and
possibly damage internal components
• the use of metal scrapers or scouring pads to clean concrete off the surface as these could damage
the housing and the protective gaskets of the Instagrid LINK MAX
• scratching or damaging parts of the Instagrid LINK MAX and pressing the tool too hard against
the housing
83 Repairs
• If you suspect an internal error (repeated triggering, unusual noises), please contact the Insta-
grid Support
• Do not open the device housing; only authorised service technicians may replace internal parts (con-
tactors, circuit breakers, IMD module, etc)
84 Spare Parts
• Spare cables (Neutrik powerCON® TRUE1®) can be obtained from Instagrid or authorised partners
• Only use original parts or spare parts approved by Instagrid to guarantee compliance with the safety
regulations
9 Transport and Storage
91 Transport
• Prior to transport, disconnect the LINK MAX from all Instagrid ONE devices and from the consumer
• Secure the device in the original packaging or another appropriate protective container during
transport
• Ensure that the device is standing upright and is protected from strong vibrations and mechanical
shocks, extreme temperatures or direct precipitation
• Check all external connections, handles and displays for damage if the device was subjected to physi-
cal impacts during transport
• Do not start up the device if you suspect it has suffered internal damage or has fallen from a
great height
31