Connecting The Cable To The Connect; Inserting The Connect Into The Mounting; Plate - Truma Inet X Connect Gebrauchs- Und Einbauanleitung

Installation
Use a pencil to mark the two positions for the button

head cap screws (Fig. 16).
Fig. 16
If necessary, pre-drill both holes with a small drill.

By pre-drilling the two holes, the two button head

cap screws can be positioned more precisely in the
wall.
Hold the mounting plate against the wall so that the

two holes are flush with the markings.
 The installation direction is specified on the mount-
ing plate.
To attach the mounting plate, screw both button

head cap screws into the wall using a Phillips screw-
driver (Fig. 17).
Fig. 17
Check the position of the mounting plate.

If the mounting plate is not straight on the wall,

adjust the position of the mounting plate.
Tighten the two button head cap screws finger tight.

Check the position of the cable again.

Prepare the cable.

20 EN
6 .8 Connecting the cable to the
Connect
Lay cables in loops to avoid tension.

Switch the power supply on again.

Insert the other plug of the cable into the CAN1 con-

nection of the Connect (Fig. 18).
When the panel is switched on and connected to the
Connect, the LED button flashes white after a few
seconds.
Fig. 18
6 .9 Inserting the Connect into the
mounting plate
 Alternatively, the Connect can be inserted into the
mounting plate rotated by 180° so that the connec-
tion for the plug of the cable is not at the bottom
(Fig. 19), but at the top.
If the LED button flashes white or lights up, move

the Connect again centrally to the mounting plate
(Fig. 19-1).
Move the Connect downwards along the mounting

plate until you hear it click into the locking hooks on
the mounting plate (Fig. 19-2).
Fig. 19
Check that the Connect has clicked into all 4 locking

hooks so that it is firmly fixed to the wall.
Truma iNet X Connect
1
2
Click!
47000-00194 · 00 · 10/2024