Routing Cables Through The Wall; Dismantling The Panel - Truma Inet X Connect Gebrauchs- Und Einbauanleitung

Truma iNet X Connect
1
Fig. 2
1 Connect
2
Panel
Distance Value
a max. 1.2 m from connection to connection
Pay attention when feeding the cable to the panel.
•
Determine a suitable place for the Connect.

Check whether the cable length is sufficient (Fig. 2).

 If the cable length is not sufficient, a cable 3, 6 or
9 metres long can be purchased from a dealership
or Truma partner.
6 .2

Routing cables through the wall

 The connection for the plug of the cable is located
on the back of the panel.
If the cable has to be routed through a wall and a hole
is required to connect the plug of the cable to the panel:
Drill a hole in the wall with a 17 mm drill or cut one

out with a 17 mm circle cutter so that the plug of the
cable fits through.
6 .3

Dismantling the panel

To be able to connect the cable and replace the connec-
tor cable with the panel cable:
Check that the back of the panel is easily accessible.

If the back of the panel is inaccessible or difficult to
access, the panel must be removed.
Unplug the button plate (Fig. 3-1) of the panel.

Fig. 3
47000-00194 · 00 · 10/2024
2
a
iNet X
Panel
1
Use a Phillips screwdriver to turn the fastening

screw (Fig. 4-1) until the installation clip faces
completely upwards.
You will see the clip in the inspection window
(Fig. 4-2).
Fig. 4
Carefully pull the panel about 20 cm forwards out of

the installation opening (Fig. 5).
Fig. 5
NOTICE
Damage due to tensile load
If plug-in connections are subjected to tension,
they may be damaged.
If plugs of (connector) cables are inserted

into the panel, do not pull on the (connector)
cables.
Feed the cable through the installation opening from

behind.
Installation
2
1
EN 17