Connecting The Cable To The Panel; Replacing The Connector Cable - Truma Inet X Connect Gebrauchs- Und Einbauanleitung

Installation
6 .4

Connecting the cable to the panel

Insert the plug of the cable into the 12 V connection

of the panel (Fig. 6).
Fig. 6
Lay cables in loops to avoid tension.

6 .5

Replacing the connector cable

The existing connector cable without termination resis-
tor must be replaced with the panel cable with termina-
tion resistor included in the scope of delivery.
Carefully unplug the connector cable (Fig. 7) up-

wards from the panel.
Fig. 7
To disconnect the two electrical wires at the other end
of the connector cable from the fuse terminal:
Turn both fastening screws with a screwdriver

(Fig. 8-1, Fig. 8-3).
Pull both cables out of the fuse terminal

(Fig. 8-2, Fig. 8-4).
18 EN
1
2
Fig. 8
 The connector cable is no longer needed.
The red electrical wire of the panel cable must be fed
into the opening of the fuse terminal, from where a red
electrical wire leads out.
The black electrical wire of the panel cable must be
fed into the opening of the fuse terminal, from where a
black electrical wire leads out.
To secure the two electrical wires of the panel cable in
the fuse terminal:
Insert both electrical wires of the panel cable into

the respective opening of the fuse terminal as far as
they will go (Fig. 9-1, Fig. 9-3).
Turn both fastening screws with a screwdriver

(Fig. 9-2, Fig. 9-4) until both electrical wires are
firmly fixed in the fuse terminal.
2
1
Fig. 9
Insert the plug of the panel cable (Fig. 10) into the

panel carefully from above without kinking the panel
cable at the transition between the panel cable and
the plug.
Truma iNet X Connect
3
4
4
3
47000-00194 · 00 · 10/2024