Inserting The Panel; Fitting The Mounting Plate - Truma Inet X Connect Gebrauchs- Und Einbauanleitung

Truma iNet X Connect
Fig. 10
6 .6

Inserting the panel

Move the installation clip (Fig. 11-1) on the back of

the panel upwards so that it is positioned horizon-
tally on the housing above the inspection window
(Fig. 11-2).
1
Fig. 11
Push the right and left sliding latches (Fig. 12-1) on

the panel against the springs (Fig. 12-2) until they
click into place on the housing (Fig. 12-3).
1
Fig. 12
Insert the control panel into the installation opening

from below (Fig. 613-1).
Gently press the housing against the installation wall

(Fig. 613-2) until you hear the sliding latches click
into the top edge of the installation opening.
47000-00194 · 00 · 10/2024
2
1
3
2
1
Fig. 13
Use a Phillips screwdriver to turn the fastening

screw (Fig. 14-1) until the installation clip faces
completely downwards.
You will no longer see the clip in the inspection
window (Fig. 14-2).
Fig. 14
Tighten the fastening screw finger tight.

Attach the button plate (Fig. 15-2) onto the frame

of the panel (Fig. 15-1).
Fig. 15
If necessary, update the firmware version of the pan-

el (see operating instructions " Truma iNet X Panel /
Truma iNet X Pro Panel").
6 .7

Fitting the mounting plate

 Use the installation template to mark the drill holes
for attaching the Connect to the wall.
Hold the installation template up against the wall.

or
Attach the installation template to the wall with

adhesive strips.
Installation
2
2
1
1
2
EN 19