Cable-Crossing - Hirschmann HiOS-2A GRS1040 Referenzhandbuch

Interface

36.4 cable-crossing

36.4.1 cable-crossing
Cable crossing settings on the interface. The cable crossing settings have no
effect if auto-negotiation is enabled. In this case cable crossing is always set
to auto. Cable crossing is set to the value chosen by the user if auto-negoti-
ation is disabled.

Mode: Interface Range Mode

Privilege Level: Operator

Format: cable-crossing <P-1>
Parameter Value
mdi
P-1
mdix
auto-mdix
RM CLI HiOS-2A GRS1040
Release 6.1 09/2016
Meaning
The port does not use the crossover mode.
The port uses the crossover mode.
The port uses the auto crossover mode.
36.4 cable-crossing
451