Configuration Steps - Telecom Behnke 20-0005-BS Anleitung

Instructions for Behnke Hybrid series 20-0005-BS, SIP intercoms series 20-0005B-IP
GB
Commissioning and Configuration

4.9. Configuration steps

Reset and restore delivery state
00 * * * #
In the case of a reset, the complete configuration is deleted and all parameters are set to the
default factory settings. A reset takes a few seconds. Meanwhile, a high-pitched beep is heard.
Enter the security code
01 new code [beep] new code #
The security code has four digits and consists only of digits. Enter the new code twice in a row.
To prevent unauthorised configuration, the default security code must be changed.
Allow configuration
02 0 # yes, via phone, keypad or display
1 # only via phone
2 # no
The configuration mode allows the configuration of the device either remotely via a telephone with
DTMF dialling or locally on the device via an existing keypad or an existing display.
It is possible to switch off the configuration on the device, i.e. via the keypad or display
and only allow remote configuration instead, i.e. via phone. Alternatively, the configuration can be
switched off completely via the configuration mode.
Call answering
03 0 # accept manually
1 # accept automatically
2 # reject
An incoming call can be accepted automatically immediately after its signalling or manually at the
touch of a button. With manual call answering, a person in front of the device can accept the call by
pressing a call button or a key on the keypad while the call is pending.
If it is set that incoming calls are to be rejected, then incoming calls are terminated as soon as they
are signalled, without an acoustic signal on the device.
Actuation time for direct call buttons
04 0 # minimally
1 # 1 second
:
5 # 5 seconds
78
:
Default: 0000
Default: 0
Default: 1
Default: 0
www.behnke-online.de