Reset To Factory Setting; Operation Of The Hybrid Intercom Station As Analogue (A/B) Intercom Station - Telecom Behnke 20-0005-BS Anleitung

Instructions for Behnke Hybrid series 20-0005-BS, SIP intercoms series 20-0005B-IP
GB
Commissioning and Configuration

4.5. Reset to factory setting

Connect the SIP intercom station to the network
Wait until the SIP intercom station is started
(see point 2 Start of the intercom station)
Press the configuration key once and follow the
prompts (to reset from factory setting, press
and hold the configuration key for at least 5
seconds).
4.6. Operation of the hybrid intercom
station as analogue (a/b) intercom
station
The configuration of the intercom station is
done via:
a. DTMF post-dialling through another analogue
phone
b. the intercom station's own WiFi
(Start network configuration mode see item 5
on page 71)
c. if the intercom station is integrated in a
network infrastructure via the web interface of
the intercom station through a PC
74 www.behnke-online.de