Telecom Behnke 20-0005-BS Anleitung Seite 77

Instructions for Behnke Hybrid series 20-0005-BS, SIP intercoms series 20-0005B-IP
4.8. Configuration of the hybrid intercom station in analogue mode
▸ Configuration by phone via DTMF post-dialling/DTMF tone:
Call the Behnke intercom station and wait until it picks up and beeps [Beep]
Press the * key once within 2 seconds after the beep is emitted [Beep]
Enter security code (default: 0000) [Beep] [Beep]
▸ Via display (if available in the intercom station):
Press display key (with the key) to display the virtual keypad
Press * key briefly [Beep]
The virtual keypad is displayed in blue.
Enter the security code
(default: 0000) [Beep] [Beep]
▸ Via keypad (if available in the intercom station):
Press the * key briefly [Beep]
Enter security code (default: 0000)[Beep] [Beep]
▸ Configuration of the a/b intercom station via web frontend:
For this purpose, the intercom station must be integrated into a network infrastructure via LAN.
See item 4.1. (operation of the hybrid intercom station as a SIP intercom station in the network),
or alternatively use the Behnke WiFi of the intercom station.
Only suitable for configuration purposes (must be started).
See also page 71 and 72 "Configuration key for an already configured device", item "Start/
exit the network configuration mode"
www.behnke-online.de
Commissioning and Configuration
GB
77