Reset To Factory Setting; Software Update - Telecom Behnke 20-0005-BS Anleitung

Instructions for Behnke Hybrid series 20-0005-BS, SIP intercoms series 20-0005B-IP
Output information
98 0 # Device type
1 # Firmware version
2 # System
3 # Serial number
4 # MAC address
5 # IP address
6 # Energy supply
7 # Detected hardware
8 # SIP registration
9 # Relay 1
10 # Relay 2
11 # Alarm input
12 # Current date
13 # Current time
This configuration step allows various information about the device in the form of a query voice
output.
Output configuration
99 Configuration step #
This configuration step allows to output other configuration steps to query the current setting.
For example, 99 21# can be used to query the call number set for key 1.

4.10. Reset to factory setting

Connect the SIP intercom station to the network
Wait until the SIP intercom station is started (see item 2 Starting the intercom station)
Press the configuration key once and follow the announcements (for reset from factory setting,
press configuration key at least 5 sec).

4.11. Software update:

To perform a software update of the intercom station, disconnect it from the a/b port and the power
supply (PoE). Integrate the intercom station into a network (optimally with Internet connection)
(see 4.1. Operation of the hybrid call station as SIP intercom station in the network). Perform soft-
ware update via web browser. Also see "Help" in the web frontend of the door intercom station.
www.behnke-online.de
Commissioning and Configuration
GB
91