Ldap Query Parameters - Fujitsu KVM s2-0411 Bedienungsanleitung

LDAP query parameters

grants it access to the directory to perform the user authentication queries specified on
the Query Parameters tab. The default values are cn=Administrator , cn=Users ,
dc=yourDomainName, and dc=com and may be modified. For example, to define an
administrator Distinguished Name (DN) for test.view.com, type cn=Administrator ,
cn=Users , dc=test , dc=view , and dc=com . This is a required field unless the directory
service has been configured to enable anonymous search, which is not the default.
Each Search DN value must be separated by a comma. The Search Password field is
used to authenticate the administrator or user specified in the Search DN field.
Use the Search Base field to define a starting point from which LDAP searches begin.
The default values are dc=yourDomainName , dc=com , and may be modified. For
example, to define a search base for test.com, type dc=test , dc=com . Each Search
Base value must be separated by a comma.
The UID Mask field specifies the search criteria for User ID searches of LDAP target
devices. The format should be in the form <name>=<%1> . The default value is
sAMAccountName=%1 , which is correct for use with Active Directory. This field is
required for LDAP searches.
5.6.4 LDAP query parameters
Clicking the Query Parameters tab displays the parameters used when performing
user authentication queries.
The appliance performs two different types of queries. Query mode (appliance) is used
to authenticate administrators attempting to access the appliance itself. Query mode
(device) is used to authenticate users that are attempting to access attached target
devices.
Additionally, each type of query has three modes that utilize certain types of information
to determine whether or not a KVM s3 Client user has access to an appliance or
connected target devices.
73
590-784-609D