Searching For A Target Device In The Local Database; Launching The Vnc Or Rdp Viewer; Customizing Properties - Fujitsu KVM s2-0411 Bedienungsanleitung

If a browser is used for access, no user name and password prompt opens.
If the Video Viewer is used for access, a user name and password prompt opens if
this is the first access attempt during the KVM s3 Client session.
After a unit is accessed, subsequent access attempts for any unit that uses the
same user name and password credentials during this KVM s3 Client session do
not require a user name and password.
The configured access method for that target device opens in a new window.
3.4.2

Searching for a target device in the local database

Click the Devices tab and insert the cursor in the Search field.
Type the search information. This could be a target device name or a property such
as type or location.
Click the Search button. The results are included in the Unit list.
Complete one of the following steps:
• Review the results of the search.
-or-
• Click the Clear Results button to open the entire list again.
Auto-searching by typing in the Unit list
Click the Devices tab, then click on any item in the Unit list.
Begin typing the first few characters of a target device name. The highlight moves
to the first target device name beginning with those characters. To reset the search
so you can find another target device, pause for a few seconds and then type the
first few characters of the next target device.
If the target device you are attempting to access is currently being viewed by another
user, you can preempt the user so you can have access to that target device, or request
a shared session with that user (KVM sharing is available only on KVM s2-0411 and
KVM s3-1621 appliances). For more information, see "Using preemption" on page 37
and "Using digital share mode" on page 40.
3.4.3

Launching the VNC or RDP Viewer

Network Access Software supports user-defined Virtual Network Computing (VNC) and
Remote Desktop Protocol (RDP) viewers. To launch either the VNC or RDP viewer,
select the Server tab from the Network Access Software. Select a server from the units
list, then click on either the VNC or RDP button at the bottom right of the screen.
3.5

Customizing properties

The Properties window in the Explorer contains the following tabs: General, Network,
Information, and, if the selected unit is a device, Connections, VNC and RDP. Use
these tabs to view and change properties for the selected unit.
590-784-609D
Searching for a target device in the local database
21