Using the KVM s3 Client Appliance Management Panel
-or-
•
Select an appliance from the Unit list, then click the Manage Appliance button.
-or-
•
Right-click on an appliance in the Unit list. Select Manage Appliance from the
pop-up menu.
-or-
•
Select an appliance in the Unit list and press Enter.
If this is the first time a unit has been accessed since the KVM s3 Client was
started, a user name and password prompt opens.
a.
Type in your user name and password. [If this is the first appliance access
since initialization or reinitialization, the default user name is admin (case
sensitive) with password admin.]
b.
Click OK to log in, or click Cancel to exit without logging in. The AMP opens.
5.1.2
Exiting the AMP
Complete one of the following steps
Click OK to save any changes and exit the AMP.
-or-
Click Cancel to exit the AMP without saving any changes.
5.2
Upgrading firmware
You can upgrade the firmware for KVM s2-0411 and KVM s3-1621 appliances or the
KVM-IAs. The KVM-IAs can be upgraded individually or simultaneously. When an
upgrade is initiated, you will see a progress bar. As long as an upgrade is in progress,
you cannot initiate another.
If you upgrade the KVM s2-0411 and KVM s3-1621 appliances firmware to a version
that supports the on-board web interface, the appliance will be available in the Migration
Wizard once the firmware upgrade is complete.
The Enable Auto-Upgrade for All KVM-IAs check box allows you to enable an auto-
upgrade for KVM-IA firmware. You can override the auto-upgrade at any stage using the
Load Firmware button described in the next section.
5.2.1
Upgrading appliances firmware
To upgrade KVM s2-0411 and KVM s3-1621 appliances firmware:
Click the Tools tab in the AMP. The Tools dialog box appears.
Click the Upgrade Appliances Firmware button.
If you have made changes in the Settings panel of the AMP, but have not yet
applied them before starting an upgrade, a warning message prompts you to
confirm the upgrade because the upgrade process requires an appliance reboot. If
you do not apply the pending changes, they will be discarded before upgrading the
firmware.
To apply those changes before the upgrade:
a.
Click No to cancel the appliance firmware upgrade.
58
590-784-609D