Fujitsu KVM s2-0411 Bedienungsanleitung Seite 131

Figure 49: Upgrade KVM-IA Firmware Window
Click Upgrade. The Upgrade button dims. The Last Status column will display
either In Progress or Succeeded, depending on the status of each KVM-IA
upgrade. A firmware upgrade currently in progress message displays until all of the
selected KVM-IA types are upgraded.
When complete, a message appears prompting you to confirm the upgrade com-
pletion. Once confirmed, the Upgrade button is again enabled.
Click Close to exit the Upgrade Firmware window.
To upgrade KVM-IA firmware individually:
Click the Configure tab in the on-board web interface.
Select the KVM-IAs sub-category under Versions in the left column.
Click the EID of the KVM-IA for which you wish to view firmware information. The
KVM-IA Version window opens.
Compare the current information to the Firmware Available field to see the firm-
ware upgrade available for the KVM-IA. (You can load firmware even if the current
and available versions are the same. In some cases, you can downgrade the KVM-
IA to an older, compatible version.)
Click the Load Firmware button.
The firmware upgrade begins. During the upgrade, a progress message is dis-
played below the Firmware Available box and the Load Firmware button will dim.
When the upgrade is finished, a message appears indicating that the upgrade was
successful.
Repeat steps 2-6 for each individual KVM-IA you wish to upgrade.
When finished, click OK.
118
590-784-609D