Setting Up A Kvm Appliance - Fujitsu KVM s2-0411 Bedienungsanleitung

-or-
• Select Tools - Discover from the software menu to search for all Fujitsu
Technology Solutions appliances.
Use the Explorer to set unit properties, options, and other customization as needed.
Select an appliance and click the Manage Appliance button to configure the
appliance for access through the appliance AMP.
From the AMP Devices category, set the names of all target devices.
Repeat steps 3 through 6 for each KVM appliance you want to manage.
After one KVM s3 Client environment is set up, select File - Database - Save to
save a copy of the local database with all the settings.
From the software on a second computer, select File - Database - Load and
browse the file you have saved. Select the file and then click Load. Repeat this
step for each client computer that you want to setup.
To access a target device attached to an appliance, select the target device in the
Explorer and click the Connect Video or Browse button to open a session (only
the corresponding button for the selected target device is visible).
For information about creating user accounts on an LDAP directory service, see
"Configuring LDAP" on page 70.
2.2.5.1

Setting up a KVM appliance

Adjust the mouse acceleration on each target device to Slow or None.
Install the appliance hardware, connect the KVM-IAs, and connect the keyboard,
monitor, and mouse to the analog port.
Connect a terminal to the serial configuration port on the rear panel of the appliance
and set up the network configuration (network speed and address type).
At the local analog computer, input all target device names using the OSCAR
interface. You can also input target device names using the KVM s3 Client.
590-784-609D
Setting up the software
11