Upgrading Kvm-Ia Firmware - Fujitsu KVM s2-0411 Bedienungsanleitung

b. Click Apply.
c. Click the Upgrade Appliance Firmware button.
-or-
To discard those changes before the upgrade, click Yes.
d. The Firmware Upgrade dialog box appears. Select TFTP Server as the
source, and type the Trivial File Transfer Protocol (TFTP) server IP address
where the firmware is located as well as the filename and directory location.
-or-
Click File System and browse to the location on your file system where the
FLASH file is located. Click Open.
Click the Upgrade button. The Upgrade button dims and a progress message
appears.
When the upgrade is complete, a message prompting you to confirm a reboot
appears. The new firmware will not be used until the appliance reboots. Click Yes to
reboot the KVM s2-0411 and KVM s3-1621 appliances. The Upgrade Firmware
dialog box will display a progress message including a message that the reboot is
complete.
-or-
Click No to reboot at a later time. You will need to reboot in order to use the new
firmware.
When upgrading KVM s2-0411 and KVM s3-1621 appliance firmware to a
i
version that supports the on-board web interface, do not exit the AMP until the
reboot is complete. If you exit prematurely, you must open the AMP after the
reboot is complete to make the appliance available in the Migration Wizard.
Click Close to exit the Upgrade Firmware window.
Do not power down the KVM s2-0411 and KVM s3-1621 appliances while it
i
is upgrading.
5.2.2

Upgrading KVM-IA firmware

You can upgrade firmware for all KVM-IAs of a given type.
To simultaneously upgrade multiple KVM-IAs:
Click the Tools tab in the AMP. The Tools dialog box appears.
Click the Upgrade KVM-IA Firmware button. The Upgrade KVM-IA Firmware
dialog box appears.
Click the checkbox in front of each type (PS/2,USB, Serial, or Sun) of KVM-IA you
wish to upgrade.
Click Upgrade. The Upgrade button dims. The Status column will display either In
Progress or Succeeded, depending on the status of each KVM-IA upgrade. A
firmware upgrade currently in progress message displays until all of the selected
KVM-IA types are upgraded.
When complete, a message appears prompting you to confirm the upgrade
completion. Once confirmed, the Upgrade button is again enabled.
590-784-609D
Upgrading KVM-IA firmware
59