Changing Global Network Values - Fujitsu KVM s2-0411 Bedienungsanleitung

5.5.1.1

Changing global network values

Click the Settings tab in the AMP.
Select the Global - Network subcategory.
Figure 17: AMP Global Network settings
In the IP Address field, enter the appliance address in IP dot notation. You can
choose either IPv4 (default) or IPv6 mode. The value cannot be a loopback address
or all zeros. This field can be modified only if DHCP or DHCPv6 is disabled.
In the Subnet Mask field, enter the appliance subnet mask in IP address dot
notation when using IPv4 mode or Prefix Length when using IPv6 mode. The value
cannot be a loopback address or all zeros. This field can be modified only if DHCP
(or DHCPv6) is disabled.
In the Gateway field, enter the appliance gateway address in IP address dot
notation. The value cannot be a loopback address. If there is no gateway address,
enter 0.0.0.0. This field can only be modified if DHCP (or DHCPv6) is disabled.
590-784-609D
Configuring Global Network settings
63