Discovering An Appliance By Ip Address - Fujitsu KVM s2-0411 Bedienungsanleitung

3.2.3

Discovering an appliance by IP address

Select Tools - Discover from the Explorer menu. The Discover Wizard opens.
Click Next. The Address Range page opens. Complete one of the following steps:
• If using IPv4 mode, select Use IPv4 address range. Type the range of IP
addresses you wish to search on the network in the To Address and From
Address boxes. Use IP address dot notation: xxx.xxx.xxx.xxx.
-or-
• If using IPv6 mode, select Use IPv6 subnet, and specify the IPv6 address and
network prefix. Use the IPv6 address/prefix format.
If you configured the KVM Switch to use non-default HTTP and HTTPS port num-
bers, type the new port numbers in the HTTP Port and HTTPS Port fields.
Click Next.
Complete one of the following steps:
• The Searching Network progress window opens. Progress text indicates how
many addresses have been probed from the total number specified by the
range, and the number of appliances found (for example, 21 of 100 addresses
probed: 3 appliances found). If one or more new appliances are discovered,
the Wizard shows the Select Appliances to Add page. From this page, you can
select the appliances to add to the local database.
-or-
• If no new appliances were found (or if you clicked Stop), the Wizard shows the
No New Appliances Found page. You can try entering a different range to
search or add the appliances manually.
Select one or more appliances to add and click the Add (>) icon to move the selec-
tion or selections to the Appliances to Add list. When the Appliances to Add list con-
tains all the appliances you want to add, click Next.
The Adding Appliances progress bar window opens. Once all of the appliances
have been added to the local database, the Discover Wizard Completed page
opens. Click Finish to exit the Wizard and return to the main window. The new
appliance is now visible in the Unit list.
If one or more appliances cannot be added to the local database for any reason,
the Discover Wizard Not All Appliances Added page opens. This page lists all of the
appliances that you selected and the status for each. The status indicates if an
appliance was added to the local database and if not, why the process failed. Click
Done when you are finished reviewing the list.
If an appliance already exists in the database with the same IP address as a discovered
unit, then the discovered unit is ignored and is not listed on the next Wizard page.
The Discover Wizard automatically finds target devices attached to the appliance. After
running the Discover Wizard, access the applicable AMP and click the Resync button
on the Devices category to find target devices attached to the appliance.
590-784-609D
Discovering an appliance by IP address
17