•
Click another tab to change additional properties.
-or
•
If finished, click OK to save the new settings.
-or-
•
Click Cancel to exit without saving the new settings.
3.5.2
Viewing and changing appliance network
properties
For an appliance, network properties include the address of the appliance.
Select a unit in the Unit list.
Complete one of the following steps:
•
Select View - Properties from the Explorer menu.
-or-
•
Click the Properties button.
-or-
•
Right-click on the unit. Select Properties from the pop-up menu.
The Properties window opens.
Click the Network tab.
In the Address field, enter the appliance address in IP dot notation or a 1 to 128
character host name. You may use an IPv4 or an IPv6 address. The address can-
not be blank, a loopback address, all zeros or a duplicate address.
Complete one of the following steps:
•
Click another tab to change additional properties.
-or-
•
If finished, click OK to save the new settings.
-or-
•
Click Cancel to exit without saving the new settings.
3.5.3
Viewing and changing target device network
properties
For a target device, network properties specify the URL to use when establishing a
browser connection to the target device. When this field contains a value, the Browse
button is visible in the Explorer task bar.
Select a unit in the Unit list.
Complete one of the following steps:
•
Select View - Properties from the Explorer menu.
-or-
•
Click the Properties button.
-or-
•
Right-click on the unit. Select Properties from the pop-up menu.
The Properties window opens.
590-784-609D
Viewing and changing appliance network properties
23