Configuring Global Session Settings - Fujitsu KVM s2-0411 Bedienungsanleitung

Using the KVM s3 Client Appliance Management Panel
In the LAN Speed field, select a value from the pull-down menu.
Complete one of the following steps:
• In the DCHP field, select Disabled or Enabled from the pull-down menu.
When enabled, the appliance gets its IP address dynamically at boot time from
a DCHP server so the IP Address, Subnet Mask, and Gateway fields are dis-
abled.
-or-
• If BootP is supported (as for the KVM s2-1611 appliance), it is visible instead of
DCHP. Select Disabled or Enabled from the pull-down menu.
You can enter the IP address for up to three DNS target devices.
DNS is not available on the KVM s2-1611 appliance.
Complete one of the following steps:
• Click Apply to save any changes without exiting the AMP.
-or-
• Click OK to save any changes and exit the AMP.
-or-
• Click Cancel to exit the AMP without saving any changes.
5.5.2

Configuring Global Session settings

Use the Global - Sessions subcategory to designate video session settings for the
appliance, including Inactivity Time-out, Preemption Time-out, Encryption Levels, and
Connection Sharing settings.
Click the Settings tab in the AMP.
Select the Global - Sessions subcategory.
64
590-784-609D