Application And Function Of Cif Module; Device Settings; Display Brightness - Wilo SiFresh Einbau- Und Betriebsanleitung

en
11.7 Application and function of CIF
module
12

Device settings

12.1

Display brightness

90
3. "Wilo Net termination".
Possible selection:
Wilo Net termination Description
Switched on System terminator is switched on.
If the system is connected at the end of the electrical bus line,
"Switched on" must be selected.
Switched off Termination resistor of the system is switched off.
If the system is NOT connected at the end of the electrical bus
line, "Switched off" must be selected.
After the termination has been changed, an individual Wilo Net address is assigned to the
participants:
In the "Settings" menu , select
1. "External interfaces"
2. "Wilo Net setting"
3. "Wilo Net address" and assign each participant its own address (1 ... 21).
Depending on the inserted CIF module type, an associated settings menu is displayed in the
menu:
"Settings"
1. "External interfaces" displayed.
The respective settings are described in the display and in the CIF module documentation.
General settings are made under "Settings"
Device settings
Display brightness
Current: 100 %
Country/language/units
Adaptation of the presentation
Bluetooth On/Off
Current: Switched off
Key lock on
Key lock: Not active
Fig. 23: Device settings
• Display brightness
• Country/language/units
• Bluetooth On/Off
• Key lock On
• Device information
• Pump kick
Under "Settings"
1. "Device settings"
2. "Display brightness"
the display brightness can be changed. The level of brightness is shown in a percent-
age. 100 % brightness corresponds to maximum possible, 5 % is the minimum pos-
sible brightness.
Installation and operating instructions • Wilo-SiFresh • Ed.02/2023-08
, "Device settings".
Set brightness of the display
and status LEDs
.