Pump Operation - Wilo SiFresh Einbau- Und Betriebsanleitung

9.2

Pump operation

Installation and operating instructions • Wilo-SiFresh • Ed.02/2023-08
Item Name
3.6 Context button
Table 7: Description of operating elements
System settings
Carry out settings by turning and pressing the operating button. Turn the operating button
to the left or right to browse the menus or configure settings. A green focus indicates nav-
igation in the menu. A yellow focus indicates a configuration of settings.
• Green focus: Navigation in menu.
• Yellow focus: Change settings.
• Turn : Menu selection and parameter setting.
• Press : Activation of menus or confirming settings.
Press the Back button (Item 3.5 in the "Description of operating elements" section) to
change the focus back to the previous focus. Consequently, the focus moves one level fur-
ther up in the structure or to a previous setting.
Pressing the Back button
firming the changed value returns the focus to the previous focus. The adjusted value will
be discarded. The previous value remains unchanged.
If the Back button is pressed for more than 2 seconds, the Home screen opens and the
system can be operated from the main menu.
NOTICE
If there are no warning or error messages, the display on the electronic
module will switch off 2 minutes after the last time it was operated.
• If the operating button is pressed or turned again within 7 minutes, the
previously exited menu will appear. You can continue to configure set-
tings.
• If the operating button is not pressed or turned for more than
7 minutes, any unconfirmed settings will be lost. Pressing the button
again opens the Home screen on the display and the system can be oper-
ated from the main menu.
Initial settings menu
The Initial settings menu will appear in the display during initial commissioning of the sys-
tem.
WELCOME - WILO-SiFresh
Start with factory settings
Circulation mode for cold water
Start venting
Automatic procedure
Help
About SiFresh
Fig. 12: Initial settings menu
Explanation
Opens the context menu with additional options and func-
tions.
Turns key lock on or off in combination with the back but-
ton. > 5 seconds.
after having changed a setting (yellow focus) without con-
en
The system has been
successfully
installed!
The pump is
currently running in
factory setting:
Circulation mode
75