Stryker Altrix 8001 Bedienungsanleitung Seite 26

3. Tap Confirm.
C C o o n n n n e e c c t t i i n n g g t t h h e e i i n n s s u u l l a a t t e e d d h h o o s s e e s s
To connect the insulated hoses:
1. To connect, push back on the retaining collar of the port on the controller (Figure 9).
2. Push the hose into an upper or lower port (Figure 10) and release the collar until the retaining collar clicks into place
(Figure 11).
N N o o t t e e - - Connect a set of ports for proper water flow.
F F i i g g u u r r e e 1 1 0 0 – – C C o o n n n n e e c c t t t t h h e e h h o o s s e e s s
D D i i s s c c o o n n n n e e c c t t i i n n g g t t h h e e i i n n s s u u l l a a t t e e d d h h o o s s e e s s
To disconnect the insulated hoses:
1. To disconnect, push back on the retaining collar of the port on the controller.
2. Pull the hose to disconnect.
C C o o n n n n e e c c t t i i n n g g a a n n d d d d i i s s c c o o n n n n e e c c t t i i n n g g t t h h e e r r m m a a l l t t r r a a n n s s f f e e r r d d e e v v i i c c e e s s
Read the operations manual for the individual thermal transfer devices for warnings, cautions, and safe operating
instructions before use.
W W A A R R N N I I N N G G
• Always use Stryker accessories. Only IEC 60601-1 equipment shall be hooked to the patient temperature ports. Failure
to comply with these instructions may invalidate any or all warranties and may negatively affect the products EMC
performance. This also protects the product from cardiac defibrillation.
• Avoid reduction in water flow. Do not connect two or more thermal transfer devices in a series on a single port.
EN 22
F F i i g g u u r r e e 9 9 – – P P u u l l l l b b a a c c k k o o n n t t h h e e r r e e t t a a i i n n i i n n g g c c o o l l l l a a r r
F F i i g g u u r r e e 1 1 1 1 – – H H o o s s e e s s c c o o n n n n e e c c t t e e d d
8001-109-005 Rev AA.3