Stryker Altrix 8001 Bedienungsanleitung Seite 49

6. To fully drain the hoses, raise all the hoses (Figure 33) above the connection ports on the controller.
N N o o t t e e - - For best performance, hang the hoses to keep them raised. Do not lower the hoses until you have completed the
disinfection and rinsing process.
7. Allow the controller and hoses to drain for a minimum of two minutes.
8. Push down on the drain plug to close the drain.
9. Empty the water from the drain pain, if applicable.
D D i i s s i i n n f f e e c c t t i i n n g g t t h h e e i i n n t t e e r r n n a a l l w w a a t t e e r r c c i i r r c c u u i i t t a a n n d d h h o o s s e e s s
1. Use personal protection equipment as recommended by the K K l l o o r r k k l l e e e e n n M M e e d d i i c c a a l l or equivalent disinfectant
manufacturer's instructions for use.
2. Put 2 K K l l o o r r k k l l e e e e n n M M e e d d i i c c a a l l tablets into the reservoir.
3. Using appropriate measuring equipment, fill the empty reservoir with 1 gallon (3.8 L) of sterile distilled water.
N N o o t t e e - - A A l l w w a a y y s s a a l l l l o o w w t t h h e e d d i i s s i i n n f f e e c c t t a a n n t t t t a a b b l l e e t t s s t t o o c c o o m m p p l l e e t t e e l l y y d d i i s s s s o o l l v v e e b b e e f f o o r r e e s s t t a a r r t t i i n n g g t t h h e e 2 2 0 0 m m i i n n u u t t e e d d i i s s i i n n f f e e c c t t i i o o n n
c c y y c c l l e e . .
4. Place the reservoir into the controller.
5. Disconnect the bottom hose from the bottom right port (Figure 34).
8001-109-005 Rev AA.3
F F i i g g u u r r e e 3 3 2 2 – – C C l l i i k k - - T T i i t t e e h h o o s s e e e e n n d d s s a a r r e e c c l l o o s s e e d d a a n n d d c c l l a a m m p p s s a a r r e e o o p p e e n n
F F i i g g u u r r e e 3 3 3 3 – – R R a a i i s s e e t t h h e e h h o o s s e e s s
B
A
45 EN