Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.4 UNPACKING
When the mower is supplied solely on the pallet, remove all the packaging materials and element securing
ƒ
the mower against movement during transportation.
When the mower is supplied on a pallet with a crate, first remove the crate using a suitable tool (crowbar,
ƒ
hammer, etc.), remove all the separately packaged assemblies and then finally remove all the securing
elements and packaging materials. Ensure that no part of the mower or its assemblies are damaged.
Visually inspect the mower and the separate assemblies for damage that may have occurred during
ƒ
transport. In the event of any type of damage, immediately contact the supplier and do not continue with
the assembly of the mower.
After unpacking everything, ensure that the packaging material is properly disposed of. The disposal
must conform to relevant waste disposal laws valid in your country. In the event that you are unsure
about the disposal procedure, have this performed by a specialised company.
The separate assemblies must be mounted back on to the mower:
(1) Ballast
(2) Top part of the protective frame
(3) Linear motor
1
(4) Grass catcher lid
(5) Grass catcher
(6) Rear plate and its right and left side
(7) Small chute
The above list does not contain all the parts and steps necessary for the assembly of the mower to
a working state. Details about the installation of the listed assemblies
SEPARATELY PACKED ASSEMBLIES
Leave the mower on the pallet and then proceed according to
INTO OPERATION.
1.5 MOWER DOCUMENTATION
The mower is supplied with the following documentation:
- Packaging note
- user's manual
- user's manual for the engine
- user's manual for the battery
- service log book
4 PREPARATION FOR PUTTING
96
4.1 INSTALLATION OF
Werbung
Inhaltsverzeichnis
