Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.4 LUBRICATION
Lubricate the respective parts of the mower according to the operating hour intervals presented on the figures
below. In the event that the mower is operated in very dusty or sandy operating conditions, lubricate more
frequently.
Prior to starting lubrication, the engine must be turned off and all moving parts of the mower must be still.
Ball bearings of the tension pulleys, guide sleeves and bearings on the mowing deck are self-lubricating.
Explanations:
10 50
.......................................................... Interval in hours
................................................................. Plastic lubricant A00
...................................................................... Oil SAE 30
Front axle:
(1)
Front wheel shafts (for lubrication it is necessary to remove the wheels)
(2)
Knuckle pins of the axle housing
Pedals:
(1) Brake pedal sliding sleeve
(2) (3) Forward and reverse travel pedal sliding sleeves
(4) Pedal rocker sliding sleeve
(5) Pedal coupler pins
Mowing deck lifting mechanism:
(1) Rotating points of the bracket
(2) mowing pins
(3) arm pins
(4) vertical draw bar pins
Grass catcher lifting mechanism:
(1) (2) (4) (5) Lifting mechanism arm pins
(2) Grass catcher housing in the rear plate
Mowing blade drive gear boxes:
Regularly inspect the oil level via the oil gauge (1) on the mowing blade drive gearboxes.
ƒ
Oil type
ƒ
When replacing the oil, use the drain bolt (2).
ƒ
2.4 TECHNICAL PARAMETERS.
152
Werbung
Inhaltsverzeichnis
