Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Parts for locking the grass catcher lifting springs:
ƒ
These parts are necessary for removing the mowing deck from the mower
5.2 DRIVER'S LOCATION
ADJUSTING THE SEAT
For the comfort of the driver when controlling the mower, it is possible to adjust the position of the seat:
The seat can be set in the forward-backward direction in a range of 160 mm using the lever located
ƒ
below the seat (1). The lever is released in the horizontal direction towards the seat.
The angle of the backrest is adjustable using the lever in the left armrest (2).
ƒ
The suspension hardness can be set using the front lever (3). Lift the lever, slide it to the required
ƒ
level and secure it in place by tilting it downwards.
STEERING WHEEL ADJUSTMENT
Depending on your body dimensions and individual preferences, it is possible to set the angle and/or height
of the steering wheel:
The clamping lever (1) is intended for setting the angle of the steering wheel within a 60° range.
ƒ
Release the lever by pulling it towards yourself, set the steering wheel to the desired position and
then lock in the lever by pushing it away from yourself.
To adjust the height, it is first necessary to remove the spring pin (3) with a diameter of 6 mm. Then
ƒ
slide the steering wheel out upwards so as to uncover the second hole of the steering wheel shaft (2).
Seat the steering wheel back on to the shaft and turn it so that the holes in the steering wheel and
ƒ
the shaft align. Then insert the spring pin into the hole and knock it in using a hammer.
(1)
Flat screwdriver (for click-ins)
(2)
Key No.10
(3)
Key No.17 (for mowing blades)
(4)
Description of tightening/loosening
(5)
Tensioning of the primary belt spring for
tensioning the spring of the primary belt
(6)
Tensioning of the secondary belt spring for
tensioning the spring of the secondary belts
(7)
Key No.15
(8)
Key No.13
(9)
Key No.24 (for grass catcher sensor)
(10) Tensioning of the travel belt spring
122
Werbung
Inhaltsverzeichnis
