Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REPLACING FUSES
In the event that any of the fuses is damaged, the broken fuse indicator light will be shown on the fuse box (the
circuit must be active). If this happens, it is necessary to replace the faulty fuse with a new one. ATTENTION:
The fuse in position 2 is active even without the key turned on.
Under no circumstances should you replace a faulty fuse with a fuse that has a higher current rating!
Under no condition may you bridge the fuses.
FUSES UNDERNEATH THE SEAT
Fuses are accessible after removing the cover located under the seat and after
ƒ
removing the fuse cover. The fuses are in the board with the indicator, which
is lit in the case of a faulty fuse.
Fuses and their values
ENGINE FUSE
Open the hood.
ƒ
The fuse is located on the right side of the frame. The fuse is located on the
ƒ
right side of the frame. Take out the fuse and insert a new fuse of the same
value
2.4 TECHNICAL PARAMETERS.
REPLACING WHEELS
In the event of a damaged wheel (hole, tear, cut, etc.) remove the damaged wheel and contact the vendor to
arrange a replacement wheel. Before removing the wheel:
Park the mower on an even surface.
ƒ
Turn off the engine, pull the key out of the ignition and engage the parking brake.
ƒ
Wheel of the front axle:
Lift the front part of the mower and secure the mower in place according to the procedure in
ƒ
THE MOWER.
Remove the protective cover (1) from the wheel.
ƒ
Using a screwdriver remove the retaining ring (2) and remove the spacer washers (3).
ƒ
Before attaching a new wheel, clean all parts and grease the shaft (4) with a plastic lubricant.
ƒ
Slide the new wheel on to the shaft, insert the washer and secure in place using a retaining ring. Finally,
ƒ
put on the protective cover.
Wheel of the rear axle:
Lift the mower and secure the it in place according to the procedure in
ƒ
Screw off the nuts (1).
ƒ
Pull the wheel off the hub (2).
ƒ
Before putting on the new wheel, clean all the contact surfaces.
ƒ
Slide the new wheel on to the hub and screw on the nuts with the cone facing towards the wheel.
ƒ
REPAIRING A TYRE PUNCTURE
The mower is equipped with tubeless tyres. In the event of a puncture, have it repaired at a specialised tyre
repair shop or at an authorised SECO mower service centre.
2.4 TECHNICAL PARAMETERS.
149
LIFTING THE MOWER.
LIFTING
Werbung
Inhaltsverzeichnis
