Packaging - Seco MP 122 Diesel Bedienungsanleitung

1 DELIVERY
The unpacking, assembly and its preparation for operation is usually performed by the vendor within the scope
of the pre-sale service. In the event that you have received your mower already assembled and ready for
operation, please skip to chapter 3 of this manual.
In exceptional circumstance a situation may arise, where the end customer may have to unpack the mower
themselves. If this is your case, continue according to the following sub-chapters.

1.1 PACKAGING

The riding mower is supplied in two forms:
Packaged on a pallet – in this form the mower is complete and no assembly is necessary.
ƒ
On a pallet in crate packaging – in this form, for transportation reasons, certain mower assemblies are
ƒ
removed and it is necessary to mount them back on to the mower before putting it into operation.
Inspect immediately after delivery that the riding mower has not been damaged. In the event of damage
inform the carrier. If the complaint is not lodged in time, no potential demands can be claimed.
Check that the mower model is the same as you ordered. In the event of an irregularity do not unpack
the mower and immediately report this discrepancy to the supplier.
1.2 HANDLING THE DELIVERY
The package must only be handled by means of a forklift truck or pallet mover. Slide the forks into the hole
in the pallet and move the mower to your selected location for its assembly or storage. Always transport only
a single box.
The minimum load bearing capacity of the handling equipment is:
The wooden crate is not intended to be lifted by means of a crane.
Only persons with relevant authorisation and experience with the operation of the handling equipment
may use it.
Due to the considerable weight of the packaged mower, we recommend at least two people for its
handling.
1.3 STORAGE BEFORE UNPACKING
In the event that the mower will not be unpacked and assembled immediately upon deliver, store it under the
following conditions:
- Store the mower in its original packaging in a dry area protected against the effects of weather, which could
result in the damage of the packaging and deterioration of condition.
- Do not tilt the wooden crate on its side or, worse still, turn it upside down. Do not place any items on to the
crate from which liquids could potentially leak.
- Do not disassemble the mower from the pallet and do not turn it on its side and do not lean it in a diagonal
position.
- Do not place any other items or materials on to the packed mower.
- When storing multiple packaged mowers then no more than two packages may be stacked on top of each other.
Recommended storage location specifications:
Temperature ............................................................ from -10 °C to +35 °C
Air humidity ............................................................. <80 % at 21 °C
Air cleanliness ......................................................... Dust-free environment
Other........................................................................ Dry storage location
800 kg
95