Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Raise the grass catcher.
ƒ
Set the mowing deck height to position 3 (without the engine
ƒ
and mowing deck running).
Turn off the mower and engage the parking brake.
ƒ
Approach the mower from behind and lift the front part of
ƒ
the chute (1) upwards to release it from the pins (2) on the
mowing deck. Then pull the chute backwards from the guide
rails (3). Thoroughly clean all parts of the chute.
After cleaning, slide the chute into the guide rails and then
ƒ
set it on the pins on the mowing deck.
EMERGENCY TRAVEL SYSTEM
The mower is equipped with a special emergency travel system that makes it possible to start the engine in an
emergency and drive the mower back in the event of some kind of malfunction of the sensors that prevents the
mower from being started after meeting all the starting conditions.
Procedure for activating the emergency travel system:
Get off the seat.
ƒ
Push down the brake pedal.
ƒ
Set the ignition key to the ON position.
ƒ
Press the R button 5×. The service symbol will appear. ATTENTION: If you don't manage to do this within
ƒ
10 seconds (the set starting interval), repeat the above described steps.
The engine can be started without the other sensors. Subsequently, it is possible to drive to a location for
ƒ
transport to a service garage.
It is not possible to engage the mowing deck when in the emergency travel mode.
PUNCTURE
The mower is equipped with tubeless tyres. In the event of a puncture, have it repaired at a specialised tyre
repair shop or at an authorised Seco mower service centre.
NEUTRAL PEDAL POSITION
If a warning triangle and the neutral or reverse symbol appears on the display, this means that the electronic
system is reporting an unperformed requirement for the neutral pedal position. Neutral position means that the
pedals are not stepped on.
In the event that the symbol appears and the pedals are in the neutral position, it is necessary to calibrate the
position of the pedal sensor.
Proceed according to
OF THE TRAVEL PEDALS AND POSITION OF THE MOWING DECK.
TOWING THE MOWER
In the event that it is necessary to tow the mower by a suitable vehicle, utilise either holes (1) in the ballast
bracket or holes (2) in the frame of the rear axle.–
6.3 REGULAR CHECKS, MAINTENANCE AND ADJUSTMENTS / CALIBRATION
134
Werbung
Inhaltsverzeichnis
