Seco MP 122 Diesel Bedienungsanleitung Seite 121

GRASS CATCHER SENSOR
The grass catcher is equipped with a sensor that monitors its presence and when it is filled with mowed material.
OTHER ELEMENTS
OPENING AND CLOSING THE HOOD.
The hood opening/closing system is the following:
The hood is unlocked using a lever (1) located at the front right wheel. After unlocking it, the hood
ƒ
is lifted upwards, where it locks itself in position.
To close the hood it is necessary to first release (pull out) the locking pin (2) of the right hinge of
ƒ
the hood and then to tilt down the hood. The lever (1) snaps back into position in which the hood
is locked in place.
ELEMENTS FOR THE PERSONAL NEEDS OF THE DRIVER
The area around the seat is equipped with elements that contribute to the driver's comfort:
At the rear part of the seat's backrest there is a compartment, e.g. for IDs, licenses, manuals, etc.
ƒ
On the right side of the mower, inside the right mudguard, you will find:
ƒ
- closable compartment (1) for small items;
- 12 V socket (2) for connecting or recharging a mobile phone or for connecting a portable flashlight;
- holder (3) for two 1.5-litre PET bottles, etc.
ATTENTION: The 12 V socket cannot be used for recharging the battery!
LOCKABLE UNDER THE SEAT COMPARTMENT
The driver's lockable under the seat compartment contains the following elements:
Electrical system elements:
ƒ
Module, six-position board for fuses with broken-fuse indicators, relay, null bridge or mowing deck soft-start.
Tools for repair and maintenance:
ƒ
10-in-1 repair and maintenance key intended for setting sensors and for standard maintenance of the mower
(1) FULL GRASS CATCHER SENSOR
Serves to signal that grass catcher is full of grass. The full level
(volume of mowed grass) and easily be set without the use of
tools by moving the sliding part of the sensor. Detailed information
is provided later in this user's manual.
(2) GRASS CATCHER PRESENCE SENSOR
The induction (contactless) sensor is mounted on the frame of the
grass catcher lifting frame and serves to monitor the presence of
the grass catcher.
ATTENTION: If the grass catcher is not present, it is not possible
to start the mowing deck.
121