Setting The Time - Seco MP 122 Diesel Bedienungsanleitung

PERFORMING A LEAK TEST ON THE HYDRAULIC CIRCUIT
Visually check the hydraulic circuit for oil leaks, namely the locations where fittings are connected
ƒ
to motors, pumps and tanks. If you discover any leaks, inform your vendor or service centre.
BLEEDING AIR FROM THE HYDRAULIC CIRCUIT
Air was bled from the hydraulic circuit of the mower prior to it being shipped from the factory. Nevertheless,
during transport or after oil is added to the tank, it may become aerated. Perform the following:
Start up the mower according to
- the working order of the servo control of the steering wheel to the left/right
- the working order of the grass catcher up/down
This will ensure that oil is filled into all the components.
Air is also automatically bled from the hydraulic circuit during the first hours of operation of the mower. We
recommend, however, to only wear in the mower under light load with warm oil for 1–2 hours.

SETTING THE TIME

As a result of the mower being disconnected from the battery for the purpose of transport from the factory, it is
necessary to again set the time when it is reconnected:
Sit on the seat.
ƒ
Push down the brake pedal (floor, left side of the mower).
ƒ
Turn the key to the ON position. The display will light up and the automatic diagnostics of the mower's electronic
ƒ
systems will take place. After 10 seconds it is possible to enter the system settings:
- Repeatedly press the cruise control button
will remain turned off). The hours digits will start flashing.
- Using the grass catcher lifting button on the right mudguard (left), set the hours value. Confirm the value
by pressing the R button on the main panel. The minutes digits will start flashing.
- Using the same button, set the minutes value and confirm it by pressing the R button. The time is now
set.
DRIVING THE MOWER OFF THE PALLET
After performing all the assembly works and inspections specified in the preceding chapters, it is possible
ƒ
to drive the mower off the pallet. For this purpose, arrange for suitable ramps that are placed in front of the
front wheels of the mower.
Start up the mower according to
ƒ
mower down off the pallet.
It is also possible to drive the mower off the pallet without starting it up. To do this, it is necessary to
ƒ
disengage the drive on the rear wheels by loosening the bypass bolt on the pump. More information
5.6 TRAVELLING ON THE MOWER / PUSHING THE MOWER.
If you decide to drive down off the pallet using the bypass, be very careful that the mower does not
accelerate when travelling down the ramps and crash into people or equipment in the room.
5.4 STARTING UP THE ENGINE, set it to low speed and test:
located on the main panel five times (the cruise control
5.4 STARTING UP THE ENGINE and slowly and carefully drive the
114