Center Of Gravity - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

173. Use canopy glue to attach the viewing window to the cockpit.
Use low-tack tape to hold the viewing window in position until
the adhesive fully cures.
174. Use a fl exible adhesive to secure the pilot in the cockpit.
175. Use canopy glue to attach the canopy to the cockpit. Use
low-tack tape to hold the canopy in position until the adhesive
fully cures.
EN

CENTER OF GRAVITY

CAUTION:
gravity and balance your model properly before attempting fl ights.
An important part of preparing the aircraft for fl ight is properly balancing the model. The Center of Gravity range
supplied here is a guideline based on testing. Deviation from the measurements we provide is possible and may result
in a model that suits your fl ying style better. Start with the recommended Center of Gravity, then feel free to experiment
with different balance points. We advise adjusting progressively and cautiously.
1. Attach the wing panels to the fuselage. Make sure to connect the leads from the aileron and fl aps to the
appropriate leads from the receiver. Make sure the leads are not exposed outside the fuselage before tightening
the wing bolts. Your model should be fl ight-ready before balancing.
2. The recommended Center of Gravity (CG) location for your model is 5
of the wing against the fuselage for sport fl ying.
3. When balancing your model, make sure it is assembled and ready for fl ight. Support the plane inverted at the
marks made on the wing with your fi ngers or a commercially available balancing stand.
 The overall CG range for this model is 4
at the measurement listed above, then adjusting to suit your particular flying style.
 Nose weight may be required when using lighter engines. Move the batteries as far
forward in the fuselage to help reduce the amount of weight required.
24
You must adjust your aircraft's center of
1
/ inches (130mm) behind the leading edge
8
11 1
/ –5 / inches (120–140mm). We recommend starting
16 2
1
5 / inches
8
(130mm)