Stabilizer Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

STABILIZER INSTALLATION

54. Remove the canopy hatch from the fuselage by sliding the
latch located behind the hatch rearward. Lift the hatch at the
rear and remove it from the fuselage. Set it aside in a safe
location.
55. Slide the wing tubes into the wing tube sockets.
56. Use a hobby knife with a #11 blade to remove the covering
for the two wing bolts and the opening for the servo leads on
both sides of the fuselage.
57. Slide the wing panel into position. Guide the fl ap and aileron
leads into the fuselage.
58. Secure the wing to the fuselage using two 1/4-20 x 1 nylon
wing bolts.
 Only one wing bolt per wing panel (near the wing
tube) is require for normal flying. Use two wing bolts
when flying your model more aggressively.
Pawnee Brave 20cc ARF
59. Repeat the steps to secure the remaining wing panel on the
fuselage.
60. Place the stabilizer in position. The control horn will be on the
bottom of the elevators when installed.
61. Stand back 8-10 feet (2-3 meters) and check that the
stabilizer is aligned with the wing. Lightly sand the stabilizer
saddle on the fuselage to correct any misalignment.
62. Measure from each wing tip to each stabilizer tip. Adjust the
stabilizer so the measurements are the same for both sides.
63. Use a felt-tipped pen to transfer the fuselage outline onto the
bottom of the stabilizer.
11
A A
A=A
A A
A=A
EN