Vertical Stabilizer Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

64. Use a hobby knife with a #11 blade to carefully cut the
covering 1/8 inch (3 mm) inside the line drawn on the bottom
of the stabilizer to remove the covering from the center of
the stabilizer. Use care not to cut into the underlying wood,
weakening the stabilizer.
65. Use a hobby knife with a #11 blade to carefully cut the
covering at the leading edge when the stabilizer comes into
contact with the fuselage.
66. Use a hobby knife with a #11 blade to carefully cut the
covering at the trailing edge when the stabilizer comes into
contact with the fuselage.
 Remove any marks from the stabilizer and fuselage
using isopropyl alcohol and a paper towel.
67. Mix 3/4 ounce (25ml) of 30-minute epoxy. Use an epoxy
brush to apply epoxy to the exposed wood on the bottom of
the stabilizer.
68. Use an epoxy brush to apply epoxy to the stabilizer mounting
surface for the stabilizer. Position the stabilizer back on the
fuselage and check its alignment. Use a paper towel and
a small amount of isopropyl alcohol to remove any excess
epoxy from the fuselage and stabilizer before the epoxy fully
cures. Allow the epoxy to fully cure before proceeding.
 Check the position of the stabilizer repeatedly during
the curing process to make sure it has not moved.
EN

VERTICAL STABILIZER INSTALLATION

69. Remove the rudder and hinges from the fi n. Place the fi n on
the stabilizer and trace the outline on the top of the stabilizer
using a felt-tipped pen.
70. Trace the outline on the top of the fuselage using a felt-tipped
pen.
71. Use a hobby knife with a #11 blade to carefully cut the
covering 1/8 inch (3 mm) inside the line drawn on the top of
the stabilizer and fuselage to remove the covering. Use care
not to cut into the underlying wood, weakening the stabilizer
or fuselage.
72. Mix 3/4 ounce (25ml) of 30-minute epoxy. Use an epoxy
brush to apply epoxy to the exposed wood on the top of the
stabilizer.
73. Use an epoxy brush to apply epoxy to the fi n mounting
surface.
12