Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung Seite 20

140. Install the throttle servo in the fuselage using the hardware
included with the servo. The output of the servo faces toward
the rear of the fuselage. Make sure to prepare the screw
holes following steps outlined earlier on this manual.
 The servo tray has locations on either side of the
fuselage for the throttle servo. Use the location that
best suits the engine selected for your model.
 When mounting the throttle servo on the opposite
side as shown in the manual, a support must
be fabricated to support the pushrod tube for
the throttle pushrod to operate properly
141. Mount the throttle servo connector in the throttle servo arm.
Place a drop of canopy glue on the M2 nut, then install it on
the underside of the arm to secure the connector.
EN
142. Center the servo using the radio system and install the servo
arm on the servo, perpendicular to the servo center line
143. Move the carburetor and servo to the low-throttle position
and tighten the setscrew securing the pushrod to the
connector at the servo. Use side cutters to trim the excess
wire. Check the operation of the carburetor using the radio
system. Make any adjustments necessary to fully open and
close the carburetor using the radio system.
144. Check the operation of the carburetor to make sure it opens
fully, and the pushrod does not bind.
145. Use side cutters to trim and excess pushrod that may
interfere with the operation of the throttle.
 The servo location opposite the throttle servo
can be used to mount a choke servo.
146. Secure the ignition module and receiver battery in the
fuselage. Use hook and loop tape and tie wraps to secure
their location. Make any connections using the instructions
provided with the engine.
20