Landing Gear Installation; Electric Motor Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

 The receiver batteries can also be mounted on the bottom
of the fuselage to provide more room on the servo tray.

LANDING GEAR INSTALLATION

104. Use two 1/2-inch wrenches to attach the axle to the landing
gear
105. Loosen the setscrews in the wheel collars using a 1.5mm hex
wrench. Remove the outer wheel collar. Slide the remaining
wheel collar tight against the hex and tighten the setscrew.
 Apply a drop of threadlock on the setscrew before
tightening to prevent it from loosening.
106. Apply a drop of light machine oil on the axle.
EN
107. Fit the wheel to the axle, then install the remaining wheel
collar on the axle. Make sure the setscrew is tightened on the
fl at area made on the axle.
 Apply a drop of threadlock on the setscrew before
tightening to prevent it from loosening.
108. Attach the landing gear to the fuselage using four M4 x 20
socket head cap screws and four M4 washers. Tighten the
screws using a 3mm hex wrench.
 Apply a drop of threadlock on each screw
to prevent it from loosening.

ELECTRIC MOTOR INSTALLATION

109. Use a pencil to extend the centerlines on the motor box.
110. Place the X-mount on the motor box. Align the holes in the
mount with the lines on the motor box. Mark the location for
the mounting holes on the motor box using a pencil.
111. Remove the mount and drill the holes for the motor mounting
screws using drill and 7/32-inch (5.5mm) drill bit.
16