Elevator Servo Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

84. Attach the tail wheel bracket to the bottom of the fuselage
using the two M3 x 12 socket head screws. Use a 2.5mm hex
wrench to tighten the screws.
85. Bend the ends of the springs so the end can be inserted
inside the coils of the spring. Make sure both springs are the
same length after bending.
86. Connect the tailwheel steering arm to the arm on the bottom
of the rudder using the two springs. Bend the loops on the
ends of the springs as necessary to attach and secure their
position.

ELEVATOR SERVO INSTALLATION

87. Install the elevator servo in the fuselage using the hardware
included with the servo. The output of the servo faces toward
the front of the fuselage. Make sure to prepare the screw
holes following steps outlined earlier in this manual.
88. Center the elevator servo using the radio system. Attach the
servo arm to the servo so it is parallel to the servo centerline.
Remove any arms from the servo horn the will interfere with
the operation of the servo and linkage using side cutters.
EN
89. When attaching the linkage to the servo arm, use the hole
that is 13/16 in (21mm) from the center of the servo horn.
This hole will need to be enlarged using a pin vise and 5/64-
inch (2mm) drill bit.
90. Attach the bend in the 3 7 / inch (98mm) to the servo arm.
8
91. Remove the clevis and nut from the two 23
pushrods. Slide both pushrods through the tubes in the
fuselage. The pushrods will exit under the stabilizer.
92. Thread the nut, then the clevis, on the pushrod. The end of the
pushrod will protrude slightly between the forks of the clevis.
 Attach the pushrods for both elevator halves.
93. Slide the elevator pushrod connector on the pushrod from the
servo. The pushrod will be in the center hole of the connector.
14
13/16 inch
(21mm)
5 / inch (600mm)
8