Battery Installation And Esc Arming; Center Of Gravity (Cg) - Horizon Hobby E-flite Carbon-Z T-28 2.0m Bedienungsanleitung

Battery Installation and ESC Arming

We recommend the Spektrum 5000mAh 6S 22.2V Smart LiPo Battery
™
30C (SPMX50006S30). Refer to the Optional Accessories list for additional
recommended batteries. If using a battery other than those listed, the
battery should be within the range of capacity, dimensions and weight of the
recommended battery packs to fit in the fuselage. Ensure the model balances at
the recommended CG.
CAUTION: Always keep hands away from the propeller. When armed, the
motor will turn the propeller in response to any throttle movement.
1. Lower the throttle and throttle trim on the transmitter to the lowest settings.
Power on the transmitter, then wait 5 seconds.
2. Apply the loop side of hook and loop tape to the bottom of your battery. The
hook material is pre-installed in the battery compartment.
3. Pull back on the release button and remove the battery hatch.
4. Install the fully charged battery in the battery compartment as shown. See the
Center of Gravity section for how to achieve proper balance of the aircraft.
5. Make sure the flight battery is secured using the included hook and loop straps.
6. Connect the battery to the ESC (the ESC is now armed).
7. Keep the aircraft immobile and away from wind or the system will not initialize.
• The ESC will sound a series of tones.
• An LED will light on the receiver.
8. Reinstall the canopy hatch.

Center of Gravity (CG)

The CG location is measured from the leading edge of the wing, where the wing
meets the fuselage. Measure the CG location with the recommended battery
(SPMX56S30) installed, with the model balanced inverted and the landing gear
extended. Adjust the battery forward or aft as needed to achieve the proper CG
location.
180mm (+/– 5mm) behind the leading edge
of the wing where it meets the fuselage.
EN
9