Removing Wrinkles; Building Precautions; Transportation And Storage; Replacement Covering - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

REMOVING WRINKLES

The covering of your model may develop wrinkles during shipping. Use a covering iron with a sealing iron sock
(HAN141) to remove them. Start with a lower heat setting and use caution while working around areas where the
colors overlap to prevent separating the colors. It is also advised to use caution around the canopy as it is plastic and
could distort with excessive heat. Avoid using too much heat, which could also separate the colors. Placing a cool
damp cloth on adjacent colors will also help prevent the separation of the colors while removing wrinkles. Only use a
heat gun (HAN100) once the covering iron has been used.

BUILDING PRECAUTIONS

Prepare the work surface prior to beginning the build. The surface should be soft and free of any sharp objects. We
recommend resting the airframe parts on a soft towel or pit mat to prevent scratching or denting the surface of the
aircraft.

TRANSPORTATION AND STORAGE

When transporting and storing your model, you will need a minimum of 80 inches (2.1m) in length, and 19 inches
(50cm) in height to accommodate the size of the fuselage. We also recommend the use of wing and stabilizer bags to
help protect these surfaces during transport and storage. The control horns and linkages can cause damage to other
surfaces even when placed in storage bags. Always transport and store the wings and stabilizer so the linkages do not
contact other panels to prevent damage.

REPLACEMENT COVERING

®
Your model is covered with UltraCote fi lm in the following colors. If repairs are required, order these coverings to
make those repairs.
White HANU870
Black HANU874
True Red HANU866

CHECKING BLIND NUTS

When building the aircraft, you will be required to thread machine screws into blind nuts. We recommend pre-threading
the screws to make sure the blind nuts are clear of any debris. If the screws do not thread in easily, clear the threads
using the appropriate tap and tap handle.
Pawnee Brave 20cc ARF

AILERON CONTROL HORN INSTALLATION

1. Use a felt-tipped pen to mark the center of the slot in the
hinges on both the wing and control surfaces.
2. Separate the aileron and fl ap from the wing. Set the hinges
aside.
3. Use a rotary tool and 1/16-inch (1.5mm) drill bit to drill the
location in the wing trailing edge and control surfaces marked
in Step 1.
4. Use medium-grit sandpaper to lightly sand the control horns
where they fi t into the control surface. Clean the sanded area
using a paper towel and isopropyl alcohol to remove any
debris or oils.
 Use tape on the painted area to help prevent removing
the paint from the exposed portion of the control horn.
Remove the tape once the control horn has been sanded.
5. Locate the control horns marked "A" for the ailerons. Test fi t
the control horns in the slots for the ailerons. Do not force the
control horn into the slot.
5 EN