Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
94. Slice the connector toward the servo. The two elevator
pushrods can then be inserted into the outer holes of the
connector.
95. Position the connector so it is centered between the elevator
and servo pushrods. Place a drop of threadlock on each
setscrew as they are tightened into position. Setscrews will
be used to secure both elevator pushrod and the pushrod
from the servo.
RUDDER SERVO INSTALLATION
96. Install the rudder servo in the fuselage using the hardware
included with the servo. The output of the servo faces toward
the front of the fuselage. Make sure to prepare the screw
holes following steps outlined earlier on this manual.
97. When attaching the linkage to the servo arm, use the hole
that is 1 inch (25mm) from the center of the servo horn. This
hole will need to be enlarged using a pin vise and 5/64-inch
(2mm) drill bit.
98. Attach the bend in the 26
3
/
inch (680mm) to the servo arm.
4
Remove any arms from the servo horn the will interfere with
the operation of the servo and linkage using side cutters.
The arm will attach perpendicular to the servo
centerline. Check this alignment before attaching the
pushrod and removing any of the servo arms.
Pawnee Brave 20cc ARF
99. Center the rudder servo using the radio system. Remove the
clevis and nut from the rudder pushrod and slide it into the
rudder pushrod tube in the fuselage. Attach the servo arm
to the servo. Remove any arms from the servo horn the will
interfere with the operation of the servo and linkage using
side cutters.
100. Thread the nut, then the clevis, on the pushrod. Attach the
clevis to the rudder control horn. with the rudder servo
centered, adjust the clevis to center the rudder.
Slide the silicone retainer over the forks of the rudder
and elevator clevises. Thread the nut away from the
clevis. Apply a drop of threadlock on the threads near the
clevis. Use pliers to tighten the nut against the clevis.
RECEIVER AND RECEIVER BATTERY INSTALLATION
101. Secure the receiver in the fuselage and route the antenna as
outlined in the receiver or radio manual. Connect the rudder
and elevator servo leads to the appropriate ports on the
receiver.
102. Remove the covering from the side of the fuselage using a
hobby knife and #11 blade. Mount the receiver switch and
connect the appropriate lead to the receiver.
1 inch
(25mm)
103. Secure the receiver battery in the fuselage using hook and
loop tape and tie wraps. Secure the lead from the battery to
the receiver switch.
15
EN
Werbung
Inhaltsverzeichnis
