Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung Seite 8

25. Use a #1 Phillips screwdriver to thread an M2.5 x 10 self-
tapping screw into each of the holes. Remove the screws
before proceeding.
26. Apply 1–2 drops of thin CA in each hole to harden the
surrounding wood. Allow the CA to fully cure before
proceeding.
27. Use a pin vise or drill and 5/64-inch (2mm) drill bit to drill
through the holes in the servo mount.
28. Thread a servo mounting screw into each hole, then remove
all the screws. Apply 1–2 drops of thin CA in each hole to
harden the surrounding wood. Allow the CA to fully cure
before proceeding. Mount the servo using the screws
provided with the servo. Note the orientation of the servo on
the servo cover
29. Secure a 9-inch (225mm) servo extension to the servo lead
using a commercially available retainer (Servo Connector
Clips, SPMA3054).
EN
30. Center the servo using the radio system. Place the control
horn on the servo so it is perpendicular to the servo. Remove
any arms from the servo horn that will interfere with the
operation of the servo.
31. When attaching the linkage to the servo arm, use the hole
that is 1 in (25mm) from the center of the servo horn. This
hole will need to be enlarged using a pin vise and 5/64-inch
(2mm) drill bit.
32. Tie or tape the string located inside the wing to the end of the
servo lead.
33. Guide the servo lead for the aileron through the wing to the
wing root.
34. Secure the aileron servo cover using a #1 Phillips screwdriver
and four M2.5 x 10 self-tapping screws.
8
1 inch
(25mm)