Herunterladen Inhalt Inhalt Diese Seite drucken

Landing Light Installation; Hinging The Elevators - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

44. With the fl ap servo centered using the radio system, adjust
the linkage to achieve the 1 inch (25mm) mid-fl ap throw.
45. Move the control at the transmitter to the raised fl ap position.
Adjust the throw percentage of throw at the radio to align the
fl ap with the trailing edge of the wing at the root.
46. Move the control at the transmitter to the full fl ap position.
Adjust the throw percentage of throw to achieve the 2
inches (60mm)
full-fl ap throw.

LANDING LIGHT INSTALLATION

47. Insert the wire into the wing for the landing light. You will
need to use a pushrod wire or similar to retrieve the wire at
the root of the wing.
 Use a hobby knife with a #11 blade or round file to
carefully enlarge the hole so the landing light fits snugly.
48. Use a small amount of silicone adhesive to glue the landing
light into position in the wing.
 Apply a drop of thin CA to the light where the lens cover
fits to secure the lens cover to the metal body of the light
EN
11
/
32
49. The landing light cover for the landing light is not symmetrical
and will conform to the airfoil of the wing. Make sure it is
oriented the correct direction when gluing it in place.
50. Use canopy glue to glue the landing light cover to the wing.
Use low-tack tape to hold the cover in position until the
adhesive fully cures.

HINGING THE ELEVATORS

51. Prepare and hinge the elevators to the stabilizer. Make sure
the tips of the elevators and stabilizer are aligned before
gluing the hinges. Make sure to verify the hinges are securely
glued before proceeding.
52. Locate the control horns marked "E" for the elevators. Use
epoxy to glue the elevator control horns in position. Allow the
adhesive to fully cure before proceeding.
53. Use a small piece of low-tack tape to hold the elevators in
alignment with the stabilizer for the next few steps.
10

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Han7035

Inhaltsverzeichnis